Good morningI have 2 ICX 7150 48P switches in stack.Image version SPS08080dBoot version mnz10114POE version icx7xxx_poe_02.1.0.b002In both switches the 1/1/1 to 1/1/8 ports are turned off.If I attack an AP the POE turns on the AP but does not pass the link.In any case, the 8-port LEDs do not light up.It can depend on thisBCM_ERR: at /vobs/fdry/build/../../../../..///vobs/platform/HAL/driver/link/sdk_al/fdry_bcm_phy_al.c: 640 while ‘bcm_port_mdix_set’ is Feature unavailableBCM_ERR: at /vobs/fdry/build/../../../../..///vobs/platform/HAL/driver/link/sdk_al/fdry_bcm_phy_al.c: 640 while ‘bcm_port_mdix_set’ is Feature unavailableBCM_ERR: at /vobs/fdry/build/../../../../..///vobs/platform/HAL/driver/link/sdk_al/fdry_bcm_phy_al.c: 640 while ‘bcm_port_mdix_set’ is Feature unavailableBCM_ERR: at /vobs/fdry/build/../../../../..///vobs/platform/HAL/driver/link/sdk_al/fdry_bcm_phy_al.c: 640 while ‘bcm_port_mdix_set’ is Feature unavailableBCM_ERR: at /vobs/fdry/build/../../../../..///vobs/platform/HAL/driver/link/sdk_al/fdry_bcm_phy_al.c: 640 while ‘bcm_port_mdix_set’ is Feature unavailableBCM_ERR: at /vobs/fdry/build/../../../../..///vobs/platform/HAL/driver/link/sdk_al/fdry_bcm_phy_al.c: 640 while ‘bcm_port_mdix_set’ is Feature unavailableBCM_ERR: at /vobs/fdry/build/../../../../..///vobs/platform/HAL/driver/link/sdk_al/fdry_bcm_phy_al.c: 640 while ‘bcm_port_mdix_set’ is Feature unavailableBCM_ERR: at /vobs/fdry/build/../../../../..///vobs/platform/HAL/driver/link/sdk_al/fdry_bcm_phy_al.c: 640 while ‘bcm_port_mdix_set’ is Feature unavailableWhat can I do?